This is with Stock Injectors and Stock Exhaust

We were at 100% Duty Cycle on the injectors around 5000 rpms. We will be adding the 60# injectors along with a new exhaust and going back to the dyno.

The engine mods installed so far are the APS twin turbo kit, 160 degree thermostat, AR103 spark plugs gapped at .035″ and an INTENSE/Dyno Tune custom tweaking. With only 6.5 psi of boost, the stock fuel injectors maxed out right around 5,000 rpm in fourth gear. Since its not a customers car, I went ahead and pushed it a little higher. Peak power came around 5,300 RPM, which is a bit beyond the stock peak of 5,200 RPM.

The best we could do last night was 473 WHP, for an increase of 182 WHP over stock with only 6.5 to 7.0 psi of boost! Not bad at all for pump gas and a SLEEPER of a car.

Well install larger fuel injectors in the next few days and try to find someone to build a 3″ dual exhaust, and then well shoot for 550 WHP next month. Im sure by July Ill be looking to turn the boost up, and then maybe well try to do this 200 mph video run that no one knows about yet.

In the above dyno chart, the green lines are completely stock, the red lines are with an INTENSE/Dyno Tune and the blue lines are with the APS kit installed.

Believe us when I tell you that this car is an absolute BLAST to drive!

z3r0 the Greatest Troll of GPONA