Looks like Flip deserves a check

_________________

Dubs:00 VW GTI VR6, Low and Slow 91 VW GTI 8v, Shave the Bay!! 91 VW Cabriolet 8v, bitch Basket
GP's:04 GP GT, Past now G-Ma's Girlfriend's 97 GP GT, "Project Pink Power"

ZZP owe's everyone on this site free Z7 turbo kits.

Milestone

_________________

Lmao

_________________

Why have more money than brains? Cuz RACE CAR :

Oh, I also wanted to add the following- If you need brake pad retainers, or new dust boots for the CALIPER PINs, you can get a complete kit from Raybestos. It was under $20 where I live.. Part # H5682A is for the front (4 brackets, 4 boots), rears # H5683A.

Also, if you want to do a caliper rebuild, you can get the following-

Piston boot + seal

CENTRIC Part # 14363032 (rear caliper, order TWO kits to do BOTH calipers)
CENTRIC Part # 14366014 (front caliper, order TWO kits to do BOTH calipers)

_________________
T66 Turbo,3" downpipes, oversized A2A,Stg3 heads/cam,hv3,built trans,bilstein struts,ssc springs,gxp brakes,pace car spoiler(1of3??),lots more.. dyno'd @ 421WHP~13lbs boost on OLD setup. New = ???

I ordered the kit from ZZperformance, I had a lot of problems and they couldn't help. I found this link and ended up sending it to them. They then put it on there web page. The problem I had with the kit was, they sent me the wrong front pads to start. Then, they didn't realize the e brake wouldn't work, so thank god I found this link. I bought the entire rear suspension from a wreckers, I decided to remove the rear bearings off the hubs and swapped over the backer plates and the ebrake equipment. I also had problems with the steel braded lines they sent me, I could have used an extra inch on all of them very tight when the suspension is fully extended. I'll post pics when I get a chance. Thanks for the great post Flip.

Is it the same step for putting c6. Z51 brake caliber on it pm let me knOw I about to order front need help wann know if they will fit and bolt. Up I got 1z comp g rims with 2 inch spacer let know thankss. Ricky