so i just put a zzp mps pulley on my car, and in the process it says take off the breather plug at the end out the snout. My question is does it go back on the car on the outside of the mps pulley or is that what the black plastic christmas tree clip that they give you is for??



thanks

_________________

I put mine back on, on the outside of the pulley, but the outside of the pulley is pretty much flush with the end of the shaft.

_________________

'05 WRX STi- AP Stage 2 tune|Invidia DP|3" Borla XR-1 CBE|TiC super shifter set|DBA 4000 rotors/SS lines|Lots of braces/poly bushings
Sold: 06 Cobalt SS/SC, 99 GTP 245WHP/326 Ft-lbs, 06 R6

ya mine is too i just didnt know if i should put the breather plug back in where it was or do i put that black plastic clip they give you there

_________________

put the breather back in

_________________

'05 WRX STi- AP Stage 2 tune|Invidia DP|3" Borla XR-1 CBE|TiC super shifter set|DBA 4000 rotors/SS lines|Lots of braces/poly bushings
Sold: 06 Cobalt SS/SC, 99 GTP 245WHP/326 Ft-lbs, 06 R6

I put mine back in also. They do give you a push pin but the fit was very tight.

_________________
99' SilverMist GTP, Special Edition Hood, Special Edition Seats, SLP Gen 2 Spolier, 3.4 MPS, Pace Setter Ceramic Coated Headers, K&N FIPK, GMPP suspension, Autolite 103's,Drilled 180 Stat, Liquid Metal Venoms, PRJ Tuned, Pres. Indy Grand Prix Club.

ok thanks i just didnt know what to do and i didnt want to mess anything up

_________________

I have a question about the same thing. I wasn't able to get mine out , I tore up the plug in the process. When i was tryin to get the rest of it out it pushed wayyyyyy back into the shaft that's not gonna hurt anything is it?

_________________
____________________
2007 supercharged GT Mods: 3.5, K&N intake, AL104s, 180* t-stat, Overkilled PCM, SD headers, 2.5" Magnaflow catback, Aeroforce, Oil pressure, and Boost gauges.