Recently installed a new PCM and I'm looking for a shop that can do the CASE Learn procedure. I called up Ourisman Chevy and they said it would be a minimum of 1 hour labor to use the Tech II.

Any suggestions? All a shop would need is a Tech II scanner right?

_________________
_________________
Joe K.
2004 Grand Prix GTP
GMPP Rear Sway Bar, Trailing Arms, F & R STB's, 180stat, Wizzair CAI, Overkill PCM, SD Headers

I thought you didn't need a case learn on 04 cars...

04-08-grand-prix-discussion-f19/security-relearn-for-2004-grand-prix-pcm-install-t1010.html

_________________

You don't need to do a case learn on the 04's.

_________________

2004 Grand Prix GTP
FWI | HP Tuner | 1.9 Rockers | Headers | 3.5 Pulley | 97-03 Control Arms w/GMPP sway bar|

I thought that was for the '97 cars. In any case, I'm not throwing a code and it's driving fine. It's an Intense/DHP tune. The instructions stated that all cars will benefit from the CASE Learn. If it's not necessary, I can put it off then. Thanks!


Charging an hour labor for something that takes a couple of minutes is ridiculous though.

_________________
_________________
Joe K.
2004 Grand Prix GTP
GMPP Rear Sway Bar, Trailing Arms, F & R STB's, 180stat, Wizzair CAI, Overkill PCM, SD Headers

I had to do a case learn on my 04 compg with a new pcm. its as simple as it gets, just read the instructions in the how to on here.

_________________

I never had to do one with my intense pcm, and if you aren't throwing a code don't worry about it.

_________________

2004 Grand Prix GTP
FWI | HP Tuner | 1.9 Rockers | Headers | 3.5 Pulley | 97-03 Control Arms w/GMPP sway bar|

You will know if you have to do a case relearn. If it doesn't turn over and the security thing is flashin at you, do a case learn.

_________________