I have a 2007 Grand Prix GXP and recently bought the halo headlights. We're trying to install them and have absolutely no idea how to even go about it. The factory headlights are hooked up through a plug, but the halos have 2 separate plugs, 2 pairs of red and white wires from the halos, and 4 pairs of black and white wires from the LEDs. Does anyone have ANY idea how to wire these up? The instructions aren't very detailed... Help would be greatly appreciated!

If i know correctly, the actual headlight/brights will wire up to where your existing headlight/brights are and the Halos can be wired up however you want them...obviously red is hot wire and black is ground...if you want the Halos to comeon w/ur fogs or driving lights, wire them up as such.

_________________

Her Name ..... Stacii Dash

hope you got em installed by now. I did mine yesterday and it took forever to wire it. It was easy enough to figure out but the actual quickconnects were a pain. How are the lights? Halos/CCFLs holding up? I hope they don't burn out quickly.

Pics?

_________________

2004 GTP Comp G. The Daily Driver.
JULY 2011 GPONA COTM
http://www.youtube.com/watch?v=9uNwgZGrvJ0
1992 GTA Trans Am. The Toy.
2003 VW Jetta. The Spousal Unit.

i have done this install. when i did mine i hooked the halos up to the led wires, then i connected the led wires to the fog lights, u will need to tap into the fog light wires with the led wires, i would suggest using a volt meter or a test light to figure out positive. also u need to use your low/high beam harness from your stock fixtures in your new fixtures, that part of install is pretty much self explanatory but if you have any questions i will do my best to answer.

-- Mon Mar 12, 2012 8:43 pm --


i believe the red halo wires connect to the white led wires and the white halo wires(which were black on my set) connect to the black led wires, u can test this by simply hooking to wires to a car battery to see if they turn on.

_________________
04 GP GT
K&N CAI, SLP Exhaust, 180 TSTAT,GMPP STB's,Tints,Weather Tech Rain Guards,Front/Rear Bumper Inserts and Rocker Panel Decals from Reflective Concepts, Windshield Banner,Reverse Bar Overlay, and Door Sills from H.O.G.,Custom Emblem from Emblem Pros,Kenwood 6X9's

and you need to use the water seal from the old headlights as well. my ccfls stopped working on the passenger side less than 24 hours after the install. faulty inverter. so now im waiting for spyder to send me a new inverter. :/ kinda sucks but at least im not being charged for it. ill post pics when i reinstall the new inverter.

EDIT: does anyone know how to aim the beams? mine are all over the place.

there should be adjustments right on the back of the fixture next to each beam, there will be an arrows and the letters u n d(for up or down)

_________________
04 GP GT
K&N CAI, SLP Exhaust, 180 TSTAT,GMPP STB's,Tints,Weather Tech Rain Guards,Front/Rear Bumper Inserts and Rocker Panel Decals from Reflective Concepts, Windshield Banner,Reverse Bar Overlay, and Door Sills from H.O.G.,Custom Emblem from Emblem Pros,Kenwood 6X9's